Product SiteDocumentation Site

6.7. Controlling Resource Start/Stop Ordering

When Apache starts, it binds to the available IP addresses. It doesn’t know about any addresses we add afterwards, so not only do they need to run on the same node, but we need to make sure ClusterIP is already active before we start WebSite. We do this by adding an ordering constraint. We need to give it a name (choose something descriptive like apache-after-ip), indicate that its mandatory (so that any recovery for ClusterIP will also trigger recovery of WebSite) and list the two resources in the order we need them to start.
# crm configure order apache-after-ip mandatory: ClusterIP WebSite
# crm configure show
node pcmk-1
node pcmk-2
primitive WebSite ocf:heartbeat:apache \
    params configfile="/etc/httpd/conf/httpd.conf" \
    op monitor interval="1min"
primitive ClusterIP ocf:heartbeat:IPaddr2 \
    params ip="" cidr_netmask="32" \
    op monitor interval="30s"
colocation website-with-ip inf: WebSite ClusterIPorder apache-after-ip inf: ClusterIP WebSiteproperty $id="cib-bootstrap-options" \
    dc-version="1.1.5-bdd89e69ba545404d02445be1f3d72e6a203ba2f" \
    cluster-infrastructure="openais" \
    expected-quorum-votes="2" \
    stonith-enabled="false" \
rsc_defaults $id="rsc-options" \